Only a few left!
This small device falses the lambda probe signal (which manages the airfuel ratio of the bike) reducing the on-off effect (typical of these models) giving a better response at low and medium revs, therefore a more fluid bike, which allows a best driving experience.
This new version is equipped with a selector that allows you to adjust the amount of addition from the modulator, in positions 1,2 and 3 respectively by 2.5%, 5% and even 7% for more extreme requests.
In position 0, the engine failure light can be turned on if needed.
Supplied with two zip tie for assembly.
ALLOWS TO AVOID RE-MAPPING WITH A DEKAT EXHAUST ON THE MOTORCYCLE
NO ENGINE FAILURE LIGHTS ON, EVEN ON THE LATEST MODELS
(excluding position 0)
The difference between this device and the eliminators (O2 killer) is that this works WITH the O2 sensor, so don't deleate it, and the ability of the bike to adjust itself is unchanged, and its effect is continuous with the progress of kms.
(The eliminators present problems that the bike "sees" that the sensor is not working as it should and adapts itself using the other sensors available.
Obviously it happens that it adapts badly, and often the engine failure light also comes on).
NOT INTENDED FOR ROAD USE!
The installation is very simple, and because it is really small it is also difficult to notice for the inexperienced eye and it hides well behind the side panels.
Installation video available soon.
NEEDED DEKAT EXHAUST
Sas plugs eliminates the sas hoses and the dongle allow to remove the sas actuator.
They give a more stable map while passing between cold and hot, makes the bike a bit richer while cold, avoid pops while using engine brake.
NOT INTENDED FOR ROAD USE !
Soon available install video
As the side stand sensor happen to fails in offroad we developed this product to avoid avoidable not running bike while in the woods
NOT INTENDED FOR ROAD USE !
Soon available install video
The clutch spring plates are used to preload the springs, and allow an increase in the power transmitted by the clutch by hardening the control on the handlebar as little as possible, which remains softer than the reinforced springs.
Cnc Made from Ergal
NOT APPROVED FOR ROAD USE
Installation video available soon
On Sale
On Sale
This Switch that allows you to turn on the radiator fan at 86 degrees instead of the over 100 of the original fan.
It prevents the engine from overheating while running it at a lower speeds.
NOT APPROVED FOR ROAD USE
The installation video will be available soon
N.B .: It is necessary to change the coolant at the same time as installing this switch
On Sale
On Sale
Superb oil filter cover (right side) for oil pressure sensor housing, machined from billet CNC in aircraft aluminum that fully Matches the OEM specifications of the component, adding a special touch to the bike.
It is supplied complete with copper gasket for the oil sensor and rubber gasket for the oil filter
Available in colors
Ktm Orange
Husqvarna blue
This manual cam chain tensioner replaces the OEM hydraulic actuator, which tends to remain seized causing unwanted rattling, and in the most serious cases, damage to the engine.
With this product you will eliminate the rattling noise, avoiding engine damage, making the bike more reliable.
Designed for a simple and comfortable assembly compared to the competition, and to avoid oil leaks in the most absolute way.
Made in Italy from ergal CNC
Use the original cap
Needs to be checked every 2000km
NOT APPROVED FOR ROAD USE
The installation video will be available soon
Shim throttle to eliminate the gap on the throttle on the with drive by wire models, to impressively improve the accuracy and guidance pleasure
Supplied with 2 spacers, needed for one bike only
NOT DOT APPROVED FOR ROAD USE